Solution (By Examveda Team) To copy the running-config to NVRAM so that it will be used if the router is restarted, use the copy running-config startup-config command (copy run start for short). Related Questions on IOS and Security Device Manager
Full Answer
Save the configuration files on both routers to NVRAM. What command did you use? copy run start Step 1: Use verification commands to check your interface configurations. a. Use the show ip interface brief command on both R1 and R2 to quickly verify that the interfaces are configured with the correct IP address and active.
What command do you type to save the configuration stored in RAM to NVRAM? To copy the running-config to NVRAM so that it will be used if the router is restarted, use the copy running-config startup-config command ( copy run start for short).
Step 1: Configure the GigabitEthernet 0/0 interface on R1. a. Enter the following commands to address and activate the GigabitEthernet 0/0 interface on R1 : b. It is good practice to configure a description for each interface to help document the network information.
Note: Click a device and then click the CLI tab to access the command line directly. The console password is cisco. The privileged EXEC password is class.
a. Enter the following commands to address and activate the GigabitEthernet 0/0 interface on R1 :
a. Use the show ip interface brief command on both R1 and R2 to quickly verify that the interfaces are configured with the correct IP address and active.