Use static routing: When administrators need complete control over the routes that are used by a router. On networks with a very small number of hosts. On networks that do not change often or that will not grow. In environments with low-capacity routers that wouldn't optimally support a dynamic routing system. To back up a dynamic route.
A network administrator can manually configure a static route to reach a specific network. Unlike a dynamic routing protocol, static routes are not automatically updated and must be manually reconfigured any time the network topology changes. A static route does not change until the administrator manually reconfigures it.
Jun 01, 2017 · To configure recursive static routes, use the following syntax: Router(config)# ip route network-address subnet-mask ip-address a. On the R1 router, configure a static route to the 192.168.1.0 network using the IP address of the Serial 0/0/0 interface of R3 as the next-hop address.Write the command you used in the space provided. b.
Configure router (Radmin FE0/0)-Go back to configuration mode-Go to interface FE0/0 to configure it-Turn on the interface port using no shut command-Assign the IP address 192.168.12.254 /24 Configure router (Radmin) - In order to save all the configuration made to the router - We have to save it to start-up config file in NVRAM - Go back to ...
Configure Static Routing is the routing that network administrator configures the network routers manually, instead of using routing protocols RIP, OSPF, etc. which utilized in the dynamic routing. The benefits of static routing are minimum bandwidth usage, no overhead on router CPU and much more and perfect for a small network with a few routers.
To perform this task, you must create a lab and configure the basic IP addressing for all PCs and Routers or download my CCNA Lab – Static Route with Cisco packet tracer. CCNA Lab – Static Route – no Configure.
Static routing is the most secure way of routing. It reduces overhead from network resources. In this type of routing we manually add routes in routing table. It is useful where numbers of route are limited. Like other routing methods static routing also has its pros and cons.
Advantage of static routing 1 It is easy to implement. 2 It is most secure way of routing, since no information is shared with other routers. 3 It puts no overhead on resources such as CPU or memory.
Administrative distance is the trustworthiness of route. Route with the lowest AD value will be chosen while forwarding the packet. By default static route has two AD values depending on the previous parameter. If you have used next hop neighbor IP address, then the default AD value will be 1. If you have used exit interface, then the default AD value will be 0. This parameter allows us to create multiple static routes for the same destination. For example we can create primary and backup path for the destination network. To create backup path, we need to set AD value to higher than default, such as 2 or 3. With this configuration router will use primary path. Due to some reason if primary route fails, the router will start using backup route automatically.
The static routing adds the security because the administrator can select to permit routing access to specific networks only and there is no bandwidth usage in between the routers as well as no overhead on the router CPU.
The static routing is most often used to transfer the routing information from 1 routing protocol to the other. The static route operations are divided into three stages such as, the network administrator can configure manually the static route on a router, the router install the route on a router and finally the packets are routed with the help ...