Mark Long Yardage Books | The most demanded yardage books on the amateur and professional golf tours. Yardage books the caddies and players use on the PGA TOUR as well as at the United States Open Championship, the PGA Championship and the Ryder Cup.
The yardage book are ubiquitous on the PGA Tour. Players and caddies carry them in their pockets and consult them before each shot. They show yardages to various targets on each hole, different points of elevation, and a close-up of the green that shows detailed contours and yardages.
What is a yardage book? Yardage books are a handbook used by golfers when playing a round. These books contain information about distances, hazards, and green complexes for every hole on the golf course. Typically, yardage book offer a little bit more information than the average scorecard.
This decision to ban green-reading material from the PGA Tour is completely player driven. It is going to be a Local Rule, as allowed by the USGA and R&A.
The great Tiger Woods for example will always carry his yardage book in his back right pocket but if he's only carrying a pin sheet without a yardage book then he will place the pin sheet in his front left pocket!
That would be an example where a competing golfer would look into his or her notebook and see that they have a note written that says missing long on the green is a bad miss, and so they will know to not hit a club that has a chance of going long.
While professional golfers still cannot use rangefinders in most competitions, they do use them during practice. For best performance during competition, training should closely relate so the athletes get the best transfer from training.
Fortunately, under the Rules of Golf, golfers are allowed to change golf balls at various points during a round. Under normal conditions -- meaning the ball wasn't damaged beyond reasonable use, or it didn't wind up in a water hazard or was lost -- a golfer can change golf balls in between holes.
Beginning in the new year, players and caddies will not be allowed to use yardage books from 2021 and prior. The TOUR will work with yardage book providers to develop the parameters of the new, approved books, which will be marked “Committee Approved Book” on the cover.
The purpose behind restricting the green-reading books is to ensure that players and caddies use only their eyes and feel to help them read the line of play on the putting green. Critics say the books offered too much assistance.
Yes. The limitation on handwritten notes is only that any hand drawn or written information about a putting green must be physically written by the player and/or his or her caddie.
0:387:41Top 5 Green Reading Tips for Golf! - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou want to look around the surrounding areas and try to find the highest point.MoreYou want to look around the surrounding areas and try to find the highest point.
Ben Hulka helps players and fellow caddies each week on the PGA Tour by selling yardage and green contour books for each course produced by former caddie Mark Long. Yardage and green contour books are a staple at PGA Tour events.
While professional golfers still cannot use rangefinders in most competitions, they do use them during practice. For best performance during competition, training should closely relate so the athletes get the best transfer from training.
0:002:13Golf Academy :: Distance Measuring Devices - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe next category is laser so this little unit shoots a laser beam out that's the flagstick reflectsMoreThe next category is laser so this little unit shoots a laser beam out that's the flagstick reflects back and tells you to the yard. How far you are to that point it's the most accurate way.
So, how are the yardages on your scorecard calculated? Short answer, golf holes are measured “across the ground” using the playing route that most golfers will take. For example, on a dogleg hole, the measurement is taken from the tee box to the apex of the dogleg.
For the most part, Ma Long has used custom-made DHS and Nittaku gear.
As you might have guessed by now, Ma Long equipment is not suited for everyone. That’s simply because your playing style will proably not match his.
Chinese players (including Long) use STIGA blades that look similar to DHS ones if you scrutinize the handle. That’s because of their sponsor.
Chinese National Team uses equipment that’s produced in China. Not surprisingly, Ma uses custom-made Ping Pong equipment as well.
These still have an edge over the newer Carbon blades. The old school blades offer better control, which can help you play faster strokes with relative ease.
For most players, Ma Long equipment is an overkill.
From STIGA OC to Nittaku Combi Wood, he has used a lot of blades in the recent times. Back in the day, he wasn’t much of an offensive player as he is now.
The basic course should be along linear features, but the controls should be large and set back 25-50m from a linear feature. Limited compass use. Legs should be 200-600m. The first couple controls should be especially easy to allow people to familiarize themselves with the map.
For instance, a long course can have expected winning times up to 100 minutes (elite men), or 80 minutes (elite women), while a sprint course will have expected winning times 12–15 minutes. As competitor speed is dependent on the terrain there is no fixed distance for course lengths, instead the course length is derived from an expected winning time, and the actual course length will vary according to the difficulty of the terrain and expected fitness of the best participants.
Both the British Orienteering Federation (BOF) and Orienteering USA (OUSA) have formal systems that define levels of technical difficulty. The BOF system has 5 levels whereas the OUSA system has 7. In both systems, novices start on a course with a technical and physical difficulty of 1 and progress according to their age, experience, and ability up to a course with a technical and physical difficulty of 5. Great care is taken to ensure that developing juniors are provided with a course that gives them a satisfying challenge without pushing them beyond their current ability.
Course (orienteering) An orienteering course is compose d of a start point, a series of control points, and a finish point. Controls are marked with a white and orange flag in the terrain, and corresponding purple symbols on an orienteering map.
When designing a course, the aim is to present a course that is suited to the ability of the competitor, and such that orienteering skills (fast map reading, running in rough terrain, finding the best route, etc.) rather than luck most likely will decide the outcome of the competition. A fair course requires a reliable map, unambiguous control points, accurate placement of control points on the map, and good and challenging course legs between the control points.
Control points should be close together, large and very easy (f.ex. trail junctions). The path should be along linear features, like trails, roads and stone walls. No compass needed. No route choice necessary. The most common complaint is that the white course was too hard. It's not unusual for an 8-year-old to be doing the course on their own. Especially the first controls should be easy.
There is also a Green course, Brown, Red, and Blue in the U.S. Yellow, Orange and Green are the only ones available to the JROTC branches, and are the usual choices for most civilians.
2. Compasses and Clinometers. A compass is an essential piece of equipment when surveying in unfamiliar territory, backcountry, or just orienting your position on a map. Compasses can be used to measure distances between two points while clinometers are used to measure the angle or elevation of slopes.
Below is a summary of eight different types of surveying equipment and their uses: 1. Chains and Tapes. Taking accurate measurements is one of the most important tasks a land surveyor must complete. There is a variety of tools that can be used to take measurements including tapes, rulers, chains, and laser devices.
Brunton Omni-Slope Sighting Clinometer – This clinometer features a precision pendulum for fast, accurate readings and is housed in lightweight aluminum for durability and portability.
SECO Hand Levels – For up-close work in even the roughest terrain, these hand levels feature lightweight but heavy-duty construction with both internal and replaceable external vial modules and 3-line mirrors to ensure a deviation of less than ¼ inch per 20 feet.
A land surveyor uses instruments to make precise measurements of the earth’s surface. From determining property boundaries to preparing construction sites, surveyors rely on certain equipment to do their jobs properly.
Spectra Precision Laser Level LL500 – Designed for long-range measurements across an entire site, this precision laser level features rugged construction, highly accurate readings, a self-leveling system, and built-in “out of level” shutoff.
Laser Measuring Devices – For the ultimate in precise measurement, laser technology is capable of measuring inclination, slope distance, and azimuth, in addition to making both vertical and horizontal calculations.
One of the most needed and useful tools that a golf course manager should have access to is a grinding machine. It’s one of those golf course maintenance equipment that helps you at several places. You need different types of grinders for golf course maintenance:
Turfgrass equipment is a must-have, especially if you use walk-behind mowers. A trailer and a utility vehicle will help workers move from one place to another quickly with the mower. You don’t want them to spend the whole day walking with the mower from one place to another.
A hydraulic equipment lifter is the most essential golf course maintenance tool that every manager should have. You have to deal with hundreds of tools and machines that you need for facility maintenance. Hydraulic lifter helps you move faulty mowers and other machines.
Hydraulic equipment lifters don’t just help you in the field, but also off the field too. For instance, you can use it in the garage to raise and lower equipment. It is definitely a must-have for golf course maintenance equipment.
You need to have all of the three types of grinders in your facility as these are used for different types of grinding and you never know what type of grinding you need.
The list can go on and on. While you might not need these tools daily, it’s important to understand where each tool plays its part and ensure they are in working condition. Golf course maintenance will become easier if you have one of these tools in your inventory all the time. You can pull the right tool when it is needed instead of borrowing or buying a new one in the middle of an emergency.
Golf course mowers are the first thing that you need for course maintenance. Not just one, but it’s important to have different types of golf course mowers to keep a well-managed course. Mowing comprises half (or more than half) of golf course maintenance. You need to have a wide range or mowing equipment available at all times.
An orienteering course is composed of a start point, a series of control points, and a finish point. Controls are marked with a white and orange flag in the terrain, and corresponding purple symbols on an orienteering map. The challenge is to complete the course by visiting all control points in the shortest possible time, aided only by the map and a compass.
Courses can have varying degrees of difficulty, both technical and physical. Courses for children and novices are made easy, while experienced competitors may face extremely challenging courses. Technical difficulty is determined primarily by the terrain and the navigational problems of crossing that terrain to locate the feature on which the control is placed. Linear features such as fences, walls, and paths generally offer low difficulty; natural features such as forest or open mo…
In a relay, all teams run the same overall course, with each team member running a part of the overall course. Different teams will run the course in a different order e.g. if the overall course consists of parts A, B, and C, teams may run ABC, BCA, or CAB.
When designing a course, the aim is to present a course that is suited to the ability of the competitor, and such that orienteering skills (fast map reading, running in rough terrain, finding the best route, etc.) rather than luck most likely will decide the outcome of the competition. A fair course requires a reliable map, unambiguous control points, accurate placement of control points on the map, and good and challenging course legs between the control points.
• Condes official website
• OCAD official website