q: which of the following settings cannot be configured through the cmos setup program? course hero

by Shea Purdy 4 min read

How to enter configuration mode for the switch in the exhibit?

26/43 Explanation After physically installing a hard disk drive and configuring it in the CMOS, you need to partition the disk and format it with a file system using Disk Management. You can use the format command to format the disk, but it has to be partitioned first. The chkdsk command is used to scan the surface of a disk and locate bad sectors or other disk problems.

How to configure DMZ settings on a small corporate network?

Cyanna Education Services, 2009 Page 4 L a b : B I O S , C M O S a n d t h e B o o t P r o c e s s 1. Enter Setup to view the boot sequence The boot sequence is the order in which the system looks for a bootable image, such as an operating system, boot floppy, or bootable CD-ROM. The most common boot sequence is floppy, CD-ROM and then hard drive, which may be represented in …

Does first hop provide redundant default gateways for end-user devices?

CMOS setup program or system setup utility ... the most common companies that write BIOS is. the boot. you always access the systems CMOS at. ROM chip, CMOS chip. the CMOS setup is stored on the_____but edits only the data on the____ ... _BIOS designed for a chipset and change it as they wish. voltage and multiplier. softmenu enables you to ...

What is a Spanning Tree Protocol?

Spanning Tree Protocol provides loop-free redundancy between switches within a LAN. However, it does not provide redundant default gateways for end-user devices within the network if a gateway router fails. First Hop Redundancy Protocols (FHRPs) provide redundant default gateways for end devices with no additional end-user configuration necessary. By using a FHRP, two or more routers can share the same virtual IP address and MAC address and can act as a single virtual router. Hosts on the network are configured with a shared IP address as their default gateway. In this Packet Tracer activity, you will configure Cisco’s Hot Standby Router Protocol (HSRP), which is an FHRP.

What is HSRP in packet tracer?

In this Packet Tracer activity, you will learn how to configure Hot Standby Router Protocol (HSRP) to provide redundant default gateway devices to hosts on LANs. After configuring HSRP, you will test the configuration to verify that hosts are able to use the redundant default gateway if the current gateway device becomes unavailable.