how to make your own golf course

by Mr. Arch Little MD 9 min read

  1. Choose a location. Your green should be built on a spot that has sandy soil, plenty of sun and good drainage.
  2. Excavate the area of your golf green to a depth of 20 inches (51 cm). ...
  3. Design the green. It should have a variety of slopes to challenge you, but ultimately slope away from the center.
  4. Install the drainage system in 8-inch (20 cm) trenches to ensure that water will drain away from the center.
  5. Put in an irrigation system if necessary. Keep in mind that adequate, even irrigation is the key to keeping turf healthy.
  6. Cover the area with a 4-inch (10 cm) layer of pea gravel. ...
  7. Add 2 inches (5 cm) of sand on top of the gravel and compact it.
  8. Top the sand with about 14 inches (35 cm) of topsoil that consists of 60 percent sand and no more than 20 percent clay.
  9. Seed or sod your green. Sodding often results in an uneven green, so seed instead if you have the time and patience to care for the grass until it ...
  10. Mark the edges of your green by sodding the perimeter with rougher grass. ...
  11. Buy your cups, pins and flags from a supplier of golf course equipment. ...

Full Answer

How to build a homemade mini golf course?

Use the landscape to your advantage Designing your golf course should be a battle against nature but rather cooperation with it. Include all the naturally-occurring obstacles such as hillocks, trees, stones, puddles, sandboxes, groves, etc. The same goes for artificial obstacles like the water sprout or the laundry pole.

How do you design a golf course?

How do you build a golf course?

How to design a golf course in your backyard?

Is it profitable to own a golf course?

Profitable golf courses are generally selling for six to eight times EBITDA, while courses that aren't profitable tend to sell at 0.8 to 1.4 times revenue.Dec 21, 2021

What does it take to make a golf course?

An average 18-hole golf course requires approximately 140 and 180 acres, while a 9-hole course requires 70 and 100 acres. A 9-hole par-3 course can be built on as little as 65 acres, while an 18-hole pitch and putt require around 25 to 30 acres.Sep 6, 2021

How do I turn my yard into a golf course?

There are four main factors that go into giving your lawn that lush, golf-course look.Mow your lawn properly. Often, people take shortcuts when it comes to mowing their lawn. ... Apply the right fertilizer (at the right times). ... Use the right amount of water (and consider irrigation). ... Stop the weeds dead in their tracks.Apr 15, 2021

How do you build a golf ground?

3:096:10How To Build A Golf Course In The Desert - YouTubeYouTubeStart of suggested clipEnd of suggested clipTo make turf smooth it must be thick. Your lawn at home has about 20,000 blades of grass per squareMoreTo make turf smooth it must be thick. Your lawn at home has about 20,000 blades of grass per square meter.

How much land is needed to build a golf course?

Golf courses require anywhere from 100 to 200 acres of land for an 18 hole championship course. The size of 18-hole golf courses can vary, sometimes drastically, but most courses are between 5,000 and 7,000 yards. But that's just the distance from hole to hole.

How long does it take to build a golf course?

The actual construction time for a golf course from ground -breaking to opening can be from one to two years, depending on the weather and amount of equipment used. But today it often takes an additional one to two years to obtain all of the permits and required approvals before construction can begin.

What kind of lawn mowers do golf courses use?

GolfGreens Mowers.Fairway Mowers.Rough Mowers.Trim and Surrounds Mowers.Fraise Mowers.Utility Vehicles.Outcross.Sprayers.More items...

What grass do they use on golf courses?

The operators of most modern-day courses prefer bentgrass or Bermuda grass on the greens. Bentgrass does well in northern climates, and Bermuda grass grows well in southern climates. You can cut both extremely low without stressing the plant, and create a smooth putting surface.

How do golf courses cut their grass?

To keep the grass so short on greens, special mowers are used. Golf course mowers are reel mowers, not rotary like most lawn mowers used at home. The reel spins and cuts the grass like a tight scissor cut. The cut height is set by adjusting the difference between the front and rear rollers.

How do you build a golf course tee box?

2:065:0204/23/2007: Tee Construction - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe staked the center line down the tees directing them towards the green on a par three with thatMoreWe staked the center line down the tees directing them towards the green on a par three with that center line in place we use the Pythagorean theorem to find the hypotenuse of a right triangle.

How do I mini golf in my backyard?

1:483:09Turn Your Backyard Into A Mini Golf Course - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt over here and I've been surprised how many holes we can fit over there and the shape and theMoreIt over here and I've been surprised how many holes we can fit over there and the shape and the beauty. And it's just the coloring it brings into the backyard it's been so. Fun.

How do desert golf courses stay green?

For those who aren't familiar with the practice, overseeding is typically done on courses with Bermuda grass, which goes dormant in winter. The top layer is scalped off and seeded with ryegrass, which grows in, allowing the course to keep its fairways, tees and greens looking nice and green for sun-starved Northerners.Oct 12, 2016

What is wikihow wiki?

X. wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors. To create this article, volunteer authors worked to edit and improve it over time. This article has been viewed 175,356 times.

How many times has wikihow been viewed?

To create this article, volunteer authors worked to edit and improve it over time. This article has been viewed 173,944 times.

Do golf courses have irrigation?

Golf course irrigation systems operate at higher pressures in order to spread the water over a wider area. However, since you only have one green to irrigate, a residential system will work well and is less expensive. ...

What is the best way to cut wood?

Some tool to cut wood like a table saw, jigsaw, or even a drill for your hole . Sandpaper or a sidewalk edge to sand your wood and make it smoother, safer and will also enable you to adhere things better. Oil or Latex based paint for your wood painting.

What is solid cardboard?

Solid cardboard, like the cardboard that is on cereal boxes compressed together, will make lots of things easier. Using different types of cardboard to create a new cardboard course with different textures.

What is mini golf?

Let your kids know what mini golf is. Mini golf is a game where players try to get a ball in a hole in the least number of shots. Mini golf is fun because you can create fun obstacles for your holes. While traditional golf is played with 18 holes, mini golf is played with nine but you can vary how many holes depending on the location.

How to cut a hole in MDF?

Cut your hole. Close to one end of your MDF panel, mark of your hole slightly off-center. Make a hole at this mark with a drill fitted with 4-inch hole saw. Flip the panel over once the drill has poked through and continue cutting the hole from the other side to prevent the MDF from splintering.

How many references are there in WikiHow?

To create this article, 15 people, some anonymous, worked to edit and improve it over time. There are 14 references cited in this article, which can be found at the bottom of the page.

How to make a bucket out of duct tape?

Community Answer. Just cut the bottom of the bucket out to make it. The lower three inches. Then you make an opening through each piece, and attach them with duct tape. Line up the (open) ends, and then you can spread them apart to make a loop. Once you've done that, screw (or tape/glue) the sides to a block.

How many people edit wikihow?

wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors. To create this article, 15 people, some anonymous, worked to edit and improve it over time. This article has been viewed 65,340 times.

Is mini golf good for kids?

This is a great course for very young children. The driveway mini-golf course is great for accuracy as the difficulty increases as you place the holes further and further away. Tape down your cups as each hole and place them at varying distances from the edge of the driveway.

What are the obstacles to a golf course?

Include all the naturally-occurring obstacles such as hillocks, trees, stones, puddles, sandboxes, groves, etc. The same goes for artificial obstacles like the water sprout or the laundry pole.

Why is sand a good surface?

Sand is a great surface because it doesn’t require any maintenance, just replenishing. The lawn, on the other side, does come with demanding upkeep requirements. First, you need to mow the fairway and then you need to mow the green. The latter is mowed by cutting the blades to the lowest possible height.

Can you use sand traps on mini golf?

Even if you opt for a mini-golf course entirely comprised of natural grass, you will have to add a few sand traps. If you already have a sandbox for children, then you can repurpose it or the new patch you created can be used by kids to play on.

What is felt board?

Felt is glued to wooden boards that add stability, as they are perfect for sections of the backyard that are covered in mud or dirt. Also, if you use boards set at an angle, the holes can be made from cut out pieces of PVC pipes to reduce weight.

Can you combine grass with felt?

What you need to know, however, is that you can easily combine a verdant lawn with patches of felt.

image

Feasibility Studies

  1. Technical– is the site you are considering suitable for a golf course? A golf course architect will examine the physical elements of the site, such as land area, topography, soils, geology, vegetat...
  2. Market– is there a market need for your golf course? Will your course fulfil market requireme…
  1. Technical– is the site you are considering suitable for a golf course? A golf course architect will examine the physical elements of the site, such as land area, topography, soils, geology, vegetat...
  2. Market– is there a market need for your golf course? Will your course fulfil market requirements, locally and potentially internationally? What demand is there and how can you satisfy this to best...

Design Concept

  • Your golf course architect will assess design opportunities and restraints and review site surveys (see common limitations below). They combine these with your objectives and vision for a successful course to create a design concept which shows potential locations of all the major elements of the project. Common limitations- the common limitations which restrict golf course …
See more on eigca.org

Masterplan

  • Once the feasibility studies are complete, the Masterplan investigates how the design concept will convert into a course people are able to play on and enjoy. This is the stage when the golf course layout, including locations for the clubhouse and maintenance facilities, the playing surfaces and landscape character, location, style and size of features, e.g. lakes, streams, walls, bridges and p…
See more on eigca.org

Planning Approval

  • Planning requirements differ greatly from one country to another and obtaining planning permission can be burdensome and lengthy. Your golf course architect will provide a detailed design package to reflect local planning submission requirements and make the planning process easier. Your golf course architect will also assist with the preparation of an Environmental Impa…
See more on eigca.org

Golf Course Construction

  • As your golf course architect understands all elements of the build and will be your project leader, they will assist in developing an accurate construction programme. Part of their role is to regularly visit the site during construction to ensure the course is built according to the contract documents and agreed timetable.
See more on eigca.org

Establishment

  • At this point in the development, your golf course will nearly be ready for play, leaving just the final details before it can open. Your golf course architect will mark out mowing lines for the greens, fairways and roughs, and sand lines for the bunkers. The final stage of making their design a reality is to establish a maintenance regime with the course superintendent to create the overall …
See more on eigca.org

Selecting A Golf Course Architect

  1. Do you want to do your own research into suitable golf course architects and approach them direct? Search the EIGCA member databaseto find an EIGCA member who fits your needs
  2. Do you want the EIGCA to do the legwork for you? Use our Member Referral Serviceby sending a brief to us and we will distribute it to our members on your behalf
  3. Do you want to organise a design competition? Find out how by using our competition guideli…
  1. Do you want to do your own research into suitable golf course architects and approach them direct? Search the EIGCA member databaseto find an EIGCA member who fits your needs
  2. Do you want the EIGCA to do the legwork for you? Use our Member Referral Serviceby sending a brief to us and we will distribute it to our members on your behalf
  3. Do you want to organise a design competition? Find out how by using our competition guidelines

Cost of Building A Golf Course

  • Golf course design fees are dependent on a variety of factors, such as the type and scale of the project, its technical complexity, the planning approval process, the working practices of the individual golf course architect and the services and conditions imposed by clients. Fees are usually calculated in one of three ways: 1. As a percentage of the construction costs 2. A fixed p…
See more on eigca.org