how to first course ahphalt shingle roof

How to install roofing shingles on a roof?

 · In today’s video we go over the basic techniques to installing shingle courses on your roof. Please like and subscribe for more instructional videos!!In the ...

How to repair an asphalt shingle roof?

To level out an existing asphalt-shingle roof, rip down (reduce the height of) two courses of shingles, as shown in the drawing below. Because asphalt shingles are routinely exposed 5 in., …

How long does it take to Shingle a roof?

 · Next, install starter courses over rake drip-edges, using the same overhang you used for eaves. Rake starter strips overlap eave starter courses when they meet at lower …

How do you do a roof reveal with shingles?

 · Place the first shingle end flush to the edge of the roof. Nail each side of the shingle to each side of the ridge, just below the shingles self-sealing strip. Install the next …

How do I start my first row of shingles?

0:525:55How To Properly Start Shingle Courses On A Roof - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst thing you're gonna want to do is take a full shingle. And you're gonna go flush. Along theMoreFirst thing you're gonna want to do is take a full shingle. And you're gonna go flush. Along the eave starter. And flush along the rake starter.

Do you need a starter course with architectural shingles?

You do need to use a starter course with architectural shingles. The starter edge will help seal the edges and cover your shingle joints. As it won't be visible on the finished roof, you don't need to worry about the look of your starter strip and whether it matches your architectural shingles.

How do you lay a starter course?

1:006:32HOW TO INSTALL THE STARTER SHINGLE - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd it's perforated and you divided in two right now we're installing the starter strip on the gableMoreAnd it's perforated and you divided in two right now we're installing the starter strip on the gable end. And five mils per shingle approximately two to three inches back from the rake.

What length should I cut my starter shingles?

Cut 12 inches (30.4 centimeters) off the length of the first shingle that you lay. Then lay down whole tiles to the end of the row, trimming the last shingle so that it fits correctly. Continue laying and nailing down shingles in this manner.

How far should shingles overhang the rake?

The edge of the shingles should hang over a roof between an inch and an inch and a half — or between a half inch and three-quarters of an inch if drip edge flashing is installed. Too much overhang and the shingles could blow off in high winds; too little can allow water to seep into rake or fascia boards.

What is starter course?

The starter course protects your roof by filling in the spaces under the edges of the first row of exposed shingles. In other words, the starter course is a backing for the first visible row of shingles.

How do you install a starter course for architectural shingles?

1:092:34ESSENTIALS OF THE STARTER SHINGLE - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe starter shingle is not optional. Especially on the eaves. But also on the gable ends on theMoreThe starter shingle is not optional. Especially on the eaves. But also on the gable ends on the right the starter shingle is necessary for complete roof install.

What is asphalt starter starter universal?

PABCO® Universal Starter is applied on the leading edge under the first course of asphalt shingles and features a sealant stripe that helps provide wind resistance for your roof system.

Basic Planning and Preparation For A Re-Roofing Job

Plan the entire job in advance, always plan for 10% roofing materials waste in your calculations, and NEVER take any shortcuts to get the job done....

Roof Shingle Types and Differences

There are two styles of asphalt shingles you can use; a 3-tab, and an architectural. Both are installed in the same manner. The difference is in th...

Roofing Materials You Will Need

Drip edge,Waterproof underlayment (ice and water shield for cold weather areas)Roll roofingRake edge flashingValley flashing (if you have valleys)S...

Roofing Shingles Installation

Start by applying the drip edge to the eaves of your roof. If your eave is one straight length, then pick an end, and work to the other. Use a roof...