how to do a starter course shingles

How to install starter shingles?

Sep 21, 2020 · Align the top edge of the starter shingles to the 7-in. control line and nail them down, four nails per shingle. If you’re installing a starter strip, align its top edge to the 7-in. control line. Next, install starter courses over rake drip-edges, using the same overhang you used for eaves. Rake starter strips overlap eave starter courses when they meet at lower corners.

How to properly start shingle courses on a roof?

For IKO’s Leading Edge Plus starter shingles, the application instructions call for four nails, one at each end, about an inch from the end of the shingle, and two more spaced equally along the shingle’s length.

What is the purpose of a starter shingle?

Jun 29, 2010 · How to Lay Shingles Step 1–Determine the Number of Shingles Needed. Estimate how many shingles it will take to cover the whole roof area. Step 2–Prepare Everything Needed. Make sure to be fully prepared with all necessary tools and materials before you start... Step 4–Prepare the Roof. Roll out the ...

What are starter shingles?

Begin a starter course by cutting off the tabs about two inches from the top of the shingle. Nail this piece into place at the roof edge so that it extends approximately two inches over the edge.

How do you take the first course of shingles?

1:155:55How To Properly Start Shingle Courses On A Roof - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt's approximately six to eight inches that gives you your exact mark where you want to cut it orMoreIt's approximately six to eight inches that gives you your exact mark where you want to cut it or there's another method for cutting. Shingles. You can go off to whip. Up. The center of your shingle.

How do I start my first row of shingles on my roof?

For the first row of shingles, called a starter course or strip, you cut the tabs off three-tab shingles and apply them with the self-sealing adhesive strip facing up along the eave. Make sure this row has a slight overhang (1/4 to 3/8 in.) beyond the drip edge.Sep 20, 2021

Should I overlap starter shingles?

1:393:53How to Install Starter Strip Roofing Shingles | Mastering the Roof by GAFYouTubeStart of suggested clipEnd of suggested clipOne and a half to three inches above the shingles bottom edge. Begin with the first nail at aMoreOne and a half to three inches above the shingles bottom edge. Begin with the first nail at a distance of one and a half to three inches.

Can you use regular shingles for starter?

The starter strip is the layer of shingles underneath the first course along the edge of the roof. Some roofers simply take regular shingles, flip them upside down and nail them down as a starter course.Dec 16, 2015