how to disamsymble and re asymmble golf course irrigation head

Using a portable compressed air tank and long blow tip, clear exhaust tubing by blowing down through the center hole in PRS housing. Clear high pressure tubing by blowing down through the manual port. Reverse the procedure and blow up from bottom of case through exhaust hole and valve probe. Rinse all components, reassemble and test rotor.

Full Answer

How do you disassemble a sprinkler head?

0:271:26Video How to disassemble and clean the filter on Rain Bird 32SA and ...YouTubeStart of suggested clipEnd of suggested clipScreen place the end of a screwdriver in the hole on the side of the filter. And lay the screwdriverMoreScreen place the end of a screwdriver in the hole on the side of the filter. And lay the screwdriver across the base and pry the filter. Out.

How do you fix a sprinkler head?

0:061:37How to Repair or Replace a Broken Sprinkler Head - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd you can try to repair it sometimes you can unscrew the top you could take it apart very easily.MoreAnd you can try to repair it sometimes you can unscrew the top you could take it apart very easily. And clean it out put it back together.

How do I remove a Rainbird sprinkler head?

0:424:51Replace SPRINKLER HEAD in 5 Minutes - Rainbird - Hunter - OrbitYouTubeStart of suggested clipEnd of suggested clipYou don't need to go all the way down because you could actually cut the sprinkler line. And if yourMoreYou don't need to go all the way down because you could actually cut the sprinkler line. And if your knife is thick enough you can use it to pry this doughnut out or just use your hands.

How long does a golf course irrigation system last?

The life expectancy of a typical irrigation system varies from 10 to 30 years, depending on the geographic location of the course and the demands on the system. Good preventive maintenance can extend a system's longevity, but sooner or later, your irrigation will need to be renovated or replaced.

How do you fix a sprinkler head riser?

0:161:48How to fix a broken sprinkler riser - YouTubeYouTubeStart of suggested clipEnd of suggested clipTurn it counterclockwise. Once you have it out you can reinstall your your new riser. ThisMoreTurn it counterclockwise. Once you have it out you can reinstall your your new riser. This particular one I use the shortest one I could find picked. It up at Home.

How do you fix an oscillating sprinkler head?

0:412:05How to Troubleshoot an Oscillating Sprinkler - YouTubeYouTubeStart of suggested clipEnd of suggested clipApply a short burst of spray lubricant to each end of the sprinkler arm if the unit does notMoreApply a short burst of spray lubricant to each end of the sprinkler arm if the unit does not oscillate wipe. Down the sprinkler with a rag corrosion rust and grime may interfere with the sprinklers.

How do you replace a rotating sprinkler head?

0:042:10Replacing A Sprinkler Head (Rain Bird 5004 Rotor Head) - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis is a quick video tutorial on how to replace a Rain Bird 5000 for sprinkler head the first stepMoreThis is a quick video tutorial on how to replace a Rain Bird 5000 for sprinkler head the first step is gonna be to dig it up alright now that you've got the Rain Bird rotor head dug up the trick to

How do you open a Rainbird sprinkler head?

0:121:53How to manually open a Rain Bird DV Series sprinkler valve - YouTubeYouTubeStart of suggested clipEnd of suggested clipI will grab the handle that's on the top of the solenoid. And twist a quarter turn counterclockwise.MoreI will grab the handle that's on the top of the solenoid. And twist a quarter turn counterclockwise. And this will manually open the valve.

How do you remove a Rainbird 5000 sprinkler head?

0:001:50How to Replace a Rainbird 5000 Sprinkler Head - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce to be able to reach underneath it to hold it unless you're in really really hard soil. And we'MoreOnce to be able to reach underneath it to hold it unless you're in really really hard soil. And we're just gonna spin it out of there. This bins out try to make sure you don't get any dirt in there.

When should I replace irrigation system?

New irrigation systems are expensive. But a system that is overdue replacement is also....Figure 1. Expected Life Cycle of Irrigation System Components*ItemYearsIrrigation system10 – 30 yearsIrrigation control system10 – 15 yearsPVC pipe (under pressure)10 – 30 yearsPump station15 – 20 yearsMar 2, 2015

How many sprinkler heads are on a golf course?

A golf course can have between 500 and 5,000 sprinklers, or even more installed throughout an 18-hole facility.

How long should sprinklers run in each zone?

Water Thoroughly: Rotor zones should run for about 30-40 minutes per zone and spray zones 10-15 minutes per zone. 2.

What causes a sprinkler head to not rotate?

The most common reason for a sprinkler to stop rotating is the accumulation of debris in the filter. This video will teach you how to clean the filter on your rotors.

How do you fix a sprinkler head that won't go down?

Why New Sprinkler Heads Won't Go DownUnscrew the cover from the sprinkler head. ... Clean any debris from the inside of the sprinkler body or on the nozzle mechanism. ... Turn the water on to the station controlling the sprinkler head. ... Reinsert the spring and nozzle mechanism back into the sprinkler head.

Why does my sprinkler head not rotate?

Highlights. The poor rotation may be caused by debris trapped in the sprinkler head. Your water filter might need to be cleaned or replaced. Poor water pressure can affect sprinkler head rotation.

Do I need to turn off water to replace sprinkler head?

Turn Off Water System - Before beginning your installation it is so important to make sure that your water system is shut off properly. If you don't get your water shut off before the installation process you will have water spraying everywhere.

What happens when you put a wrong nozzle in a sprinkler system?

As a result, the precipitation rate changes as well as the distance of throw, how much water it uses and the uniformity.

What else do irrigation maintenance personnel need to be trained about?

What else do irrigation maintenance personnel need to be trained about? If your irrigation system has smaller sprinklers that are not valve-in-head, they need to know what match precipitation is and what the flow control on a valve is for. That way the block zones water evenly and the pressure is appropriate for the sprinklers installed. Does everyone working on the irrigation system know how to make a proper wire connection – extremely important on two-wire/decoder system – that is waterproof with a consistent connector used throughout the golf course? How about something as simple as a repair coupling? Are they using solvent weld cement fittings for repairs that should be done with ductile iron or gasketed repair couplings? Do they know the proper way to install a repair coupling so it doesn’t stress the pipe and so it will last? Many golf course irrigation system repairs are repairs of previous repairs – hence the repair was probably not done correctly in the first place. Of course, there is my personnel pet peeve of keeping sprinklers level and at grade. That is preventive maintenance, not repair. Train your personnel to level and set sprinklers at grade when they are not repairing other parts of the system.

Is an irrigation system a system?

True to its name, an irrigation system is a “system.”. At some point, someone spent a considerable amount of time designing that “system” to make sure it operated correctly and applied water as uniformly and efficiently as possible given the equipment available at the time.

What happens if you have an outdated irrigation system?

An outdated or poorly designed irrigation system can result in water waste, unhealthy plant growth, dry or patchy lawns and host of other common problems. With the recent focus on water efficiency, if your irrigation was installed 5 years ago or more you may be missing out on important irrigation innovations that can save buckets ...

How to contact Impact Sprinkler?

This is a brief video on how to troubleshoot an Impact Sprinkler. If you have any questions please feel free to call us at 1-877-345-8676 Monday through Friday from 7:30Am to 4:00PM (PST) or by email .

What to do if playback doesn't begin?

If playback doesn't begin shortly, try restarting your device.

Why do we need drip irrigation?

Other benefits include water savings due to more efficient water delivery and less run off as well as the promotion of a more healthy bountiful landscape as a result of less over or under watering.

How to install Toro Blue Stripe?

Step 1 -- connect to a water source, Step 2 -- distribute the water and Step 3 -- water the plants. To make selecting the parts you need even easier, each Toro Blue Stripe Drip component has color coded packaging to match the installation step for which it should be used.

What is a golf course irrigation system?

Golf course irrigation systems operate in a dynamic and challenging environment. There are many things that can affect the performance of the system. This Troubleshooting Guide is designed to assist you in finding solutions for performance challenges that may randomly affect Rain Bird® golf rotors.

How to clean a rotor valve?

Clean valve by flushing with water, replace universal filter and reinstall valve. Pressurize water supply to rotor.