1 broadcast domainHow many broadcast domains and collision domains are on a basic 12-port switch using half-duplex mode? Answer is B. The switch creates 12 collision domains and 1 broadcast domain.
Broadcast Domain : As R1 has two ports so 2 broadcast domains because router has per-port broadcast domain. Collision Domain : As routers and switches has per-port collision domain.
4:087:07How many broadcast domains? Diagram Question CCNA - YouTubeYouTubeStart of suggested clipEnd of suggested clipBecause this router is connected to another router and in between the two routers is a third networkMoreBecause this router is connected to another router and in between the two routers is a third network right if you simply count how many interfaces on the routers.
Each switchport acts as its own collision domain and therefore on a 24-port switch there are 24 collision domains.
A router not only breaks collision domains but also breaks broadcast domains, which means it is both collisions as well as broadcast domain separators. A router creates a connection between two networks.
A broadcast domain is the portion of a network sharing the same layer 2 segment. Broadcast messages from hosts are sent to every port in their broadcast domain, thus hosts inside a broadcast domain can reach each other directly.
There is one broadcast domain and one collision domain per switch. Explanation: In Cisco LAN switches, the microsegmentation makes it possible for each port to represent a separate segment and thus each switch port represents a separate collision domain.
A broadcast domain is the domain in which a broadcast is forwarded. A broadcast domain contains all devices that can reach each other at the data link layer (OSI layer 2) by using broadcast. All ports on a hub or a switch are by default in the same broadcast domain.
A Broadcast domain is a type of Domain wherein traffic flows all over the network. The Collision domain refers to a set of devices in which packet collision could occur. Broadcast domain refers to a logical set of reachable computer systems without using a router.
So in hub world only one device can send or receive data at the same time.so hub has only 1 collision Domain. But in the switch case switch treats every port as its own collision domain.so if you have 8 port switch that means you will have 8 collision domains.
How many collision and broadcast domains are in the network shown below? Explanation: There are 7 collision domains and 2 broadcast domains.
There are 8 collision domains, one per pair of devices connected to each other (switch to router, switch to swich, switch to computer etc...)
A switch has 12 ports. How many collision domains does the switch have?
D. Bridges can base their forwarding decisions on logical network layer addresses.
Commonly used in 10base-T networks that carry data rates of 10Mbps and a maximum rate of 16Mbps.
A. Bridges can base their forwarding decisions on logical network layer addresses.
A bridge is software based and a switch is hardware based.